Miniature Accessories
Miniature Connector Grommet
The grommet can be fitted in the entrance hole of a Hamitherm miniature connector to prevent moisture and dirt from entering the connector. Has limited strain relief capabilities. Temperature rating +200°C max.
Miniature Bending Protection Seal
Bending protection for thermocouples and wire being used with Hamitherm miniature connectors. Prevents mechanical damage of wires at entrance point of the connector. Temperature rating +200ºC max.
Miniature Connector Protection Boot
Transparent, flexible, silicone rubber boots that cover the connector set snugly and prevent moisture, water and dirt ingress. Available for two pin and three pin, miniature Hamitherm connectors. Temperature rating +200°C max.
Miniature Wire Clamp Bracket
The wire clamp bracket provides optimum support/strain relief for Hamitherm miniature connector wires. Easy to fit, the construction allows a large difference in maximum and minimum wire diameters.
Barrier Terminal Block
Hamitherm terminal blocks designed for use in terminal boxes and behind panels for connection of thermocouple and RTD circuits. Accepts wires up to 3.0mm. Temperature rating +200°C max.
Terminal Lugs
Spade and ring terminal lugs. To be used as wire termination on thermocouples or on wires fitted into barrier terminal blocks. For use with the following calibration codes: K, J, T, N. Accepts wires up to 1.2mm. Supplied as a set: 1 positive terminal lug and 1 negative terminal lug.
Miniature Connector Wire Insert
Wire inserts for miniature Hamitherm connectors. Once fitted in the entrance hole they provide a very good strain relief without any protruding parts from the connector. Available with round or oval hole to fit specific wires.
Miniature Connector Crimp Insert
Crimp inserts for fitting into the entrance hole of miniature Hamitherm connectors. Designed for soldering or crimping on mineral insulated cable, or crimping on insulated wire.
